CLOSURES AND RIDGE VENT
3 Foot Closures, Tuff-Rib (outside or inside)
Made from durable polyethylene foam rubber, these Tuff-Rib closures seal the upper and lower ends of panels. Outside closures go on top of the upper end of panels, sealing between ribs. Inside closures go under the lower end of panels.
$1.35 Each
3 Foot Closures, R-Panel (outside or inside)
Made from durable polyethylene foam rubber, these R-Panel closures seal the upper and lower ends of panels. Outside closures go on top of the upper end of panels, sealing between ribs. Inside closures go under the lower end of panels.
$1.35 Each
2 Foot Closures, 5V-Crimp (outside or inside)
Made from durable polyethylene foam rubber, these 5V-Crimp closures seal the upper and lower ends of panels. Outside closures go on top of the upper end of panels, sealing between ribs. Inside closures go under the lower end of panels.
$1.35 Each
Expanding Closure, 1" x 1" x 19' 8"
This is a pre-compressed, self-expanding closure impregnated with acrylic sealant. It works great for sealing under and over panel ribs at angled areas like hips and valleys, as well as other irregular voids where regular closures cannot be used.
$24.50 / Roll
Profile Ridge Vent, Tuff-Rib
Custom cut to fit panels, Profile Vent installs under ridge caps, allowing ventilation, while keeping out bugs and wind-driven rain. We carry Tuff-Rib Profile Vent in both 2" wide x 3' strips, and 3" wide x 50' roll packages. Figure for both sides of ridge.
Profile Ridge Vent, R-Panel, 50' Rolls
Cut to fit the R-Panel / PBR-Panel system. We carry R-Panel Profile Vent in 3" wide x 50' rolls. Figure for both sides of ridge.
$120.00 / 50' Roll
Profile Ridge Vent, 5V-Crimp, 50' Rolls
Cut to fit the 5V-Crimp system. We carry 5V-Crimp Profile Vent in 3" wide x 50' roll packages. Figure for both sides of ridge.
$120.00 / 50' Roll
Profile Ridge Vent, 1" Rib Image II, 50' Rolls
Cut to fit the 1" rib, 16" wide, Image II Standing Seam system. We carry Image II Profile Vent in 3" wide x 50' roll packages. Figure for both sides of ridge. Make sure to also purchase 1" Profile Vent Clips to hold in place for this profile.
$120.00 / 50' Roll
1" Clip for Profile Vent (Image II)
Used to hold Profile Vent in place, as well as to pop rivet ridge caps to. Works for our 1" height rib Image II panels. Order 1-2 clips per panel, depending on wind uplift requirements.
$0.92 Each
Profile Ridge Vent, Vertical Seam, 100' Rolls
Cut to fit the 1-3/4" rib, Vertical Seam system. We carry Vertical Seam Profile Vent in 3" wide x 100' roll packages. Figure for both sides of ridge. Make sure to also purchase 1-3/4" Profile Vent Clips to hold in place for this profile. Choose panel width.
$255.00 / 100' Roll
1-3/4" Clip for Profile Vent (Vertical Seam)
Used to hold Profile Vent in place, as well as to pop rivet ridge caps to. Works for our 1-3/4" height rib Vertical Seam panels. Order 1-2 clips per panel, depending on wind uplift requirements.
$0.92 Each