Commercial Metal Roofing

While any of our metal roofing materials can be used in commercial applications, these products in specific are quite suited for commercial and industrial roofing uses. If you are unsure of which product will work best for your project, just give us a call.

Commercial & Industrial

R-Panel / PBR Panel

Our most popular commercial metal roofing panel, R-Panel is used for metal roofing and siding, primarily on commercial and industrial buildings. The larger 1-1/4" ribs make it a great choice for low slope roofs.
Read More about R-Panel / PBR Panel

Snap-Loc 24 - Standing Seam

With 3" high ribs and a 24" width coverage, Snap-Loc 24 can take about anything thrown its way. Primarily used for commercial roofing, Snap-Loc 24 can be installed on roofs with slopes down to 1/4:12, making it a great choice for low sloped roofs.
Read More about Snap-Loc 24

Magna-Loc - Mechanically Fastened Standing Seam

Unlike our other standing seam products which do not require a mechanical seamer, Magna-Loc is a mechanically fastened standing seam. This means that it requires a special machine to install it. With 2" high ribs, this product can be installed on roofs with slopes as low as 1/2:12.
Read more about Magna-Loc

Light Commercial & Agricultural

Tuff-Rib / Classic Rib Metal Roofing Panel

Tuff-Rib is a durable, affordable panel. The 3/4" steel ribs add strength and beauty, while providing the look of board and batten. Tuff-Rib is available in many colors with baked on enamel coatings, as well as Galvalume®. Tuff-Rib warranties are standard 40-45 years.
Read More about Tuff-Rib / Classic Rib

Vertical Seam - Standing Seam

Vertical Seam has 1-3/4" high ribs, giving it the strength needed to be installed over either open framing or solid decking. This standing seam system is fastened using hidden clips.
Read More about Vertical Seam

Image II - Standing Seam

Image II Standing Seam is a hidden interlocking fastener system, hiding the screws on both the panels and trim. The screws are fastened into a sidelap which is then hidden by the rib of the next panel. No clips are required, which saves time and money. Image II can only be installed over a solid substrate, so installation over open framing is not an option.
Read More about Image II Standing Seam